Air conditioning for woodworking shops
Keeping your shop comfortable in the hot, sticky summer months. January 16, 2001
I am planning to build a new shop, about 60 x 100. Temperatures in my current shop can reach 115 degrees. I have fans, cross ventilation, etc., but the Louisiana summers can be very hot. What kind of air conditioning/cooling systems do you use in your shops?
I have a 27 x 32 shop with 10' ceilings and a 25,000 btu in-the-wall unit. The more you can control the dust, the better you will be with a/c in the shop. I clean my filter every two days I have it running.
Through-the-wall units are cheaper to run than central units, cost less and you can install them yourself. Make sure, whichever way you go, that the filters and coils are easy to clean.
I moved the compressor into my shop and the humidity level has dropped greatly. Good insulation is important for keeping your shop cool, too.
We have a 3700' shop, masonry, with 10' ceilings. It is hot and humid here in Virginia. Heat pumps keep it cool and the cost of electricity is very reasonable.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Dust Collection, Safety, Plant Management
KnowledgeBase: Dust Collection, Safety, Plant Management: General
KnowledgeBase: Woodworking Miscellaneous
KnowledgeBase: Knowledge Base
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com