Applied Mouldings for Frame-and-Panel Doors
Tips on how to make and apply "bolection" moldings for the joint between door frame and panel. November 10, 2005
I am seeking a source for a shaper cutter or router bit that will let me make an applied molding to add to a tradional raised panel door or flat panel door. The end result would be a door with a raised molding and would require a 3/8 inch rabbet cut as a second pass. This cutter would typically have a half round and then generate a lot of height quickly with additional detail that would rest on the floating panel. Almost every high end cabinet company offers this addition detail on their door lineups. I would appreciate any help.
(Architectural Woodworking Forum)
From contributor A:
Do you have any interchangeable cutterheads for a shaper? If not, there is a variety of cutterhead designs you can choose from. You can have a custom profile made to your needs or choose an off the shelf profile. I have five different styles of heads I use for different purposes. One general use design is from Leitz tools, which I buy stock knives for, for just the same purpose as you're describing. I have one profile that sounds like what you are looking for that I selected out of their catalog. I personally wouldn't use a router bit for this, mostly because I have the tooling to do it on the shaper, so I can't direct you to any specific make and model.
From contributor B:
You are referring to a Bolection moulding or panel moulding. I just applied one of my personal bolection mouldings to to about 120 assorted doors and drawer fronts in both flat and raised panel styles. I have a very nice custom router bit for one of my bolection patterns that makes a nice moulding with a large router in a router table. I also have other bolection patterns that I run in a planer style molder. It is very time consuming stuff to miter and apply so be careful how you price the upgrade. Keep in mind that if you apply it to a raised panel, the raised panel profile must have a flat area on its edge where the bolection moulding contacts it. If you use it on a tapered raised panel edge, the panel can act like a wedge when it widens in summer and pry your moulding off of the door.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Architectural Millwork
KnowledgeBase: Architectural Millwork: Moldings
KnowledgeBase: Cabinetmaking: Cabinet Door Construction
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com