Glazing steps for the novice. April 9, 2003
Can anyone explain the procedure for glazing something? Can I use with waterbase poly?
(From WOODWEB's Finishing Forum)
From contributor M:
To simplify glazing, you can wipe or brush the glaze on a coating, then wipe a little of the excess off, then brush across the wood, leaving some of the glaze color on the coating. In some cases, you may leave some of the lines from the brush bristles. In other cases, you keep brushing until there are no brush lines. It is fairly easy to do and with a little practice you can easily master it.
Glazing can be done on every coating. There are different types of glazes. Ask your supplier what you should use.
From the original questioner:
So the glazing goes on before my 3 coats of poly?
From contributor M:
Yes. There is another process called double glazing, where after you seal the first glaze, you apply and then brush out the second glaze, and then you add another coat. This adds more color and enriches the finish. You can also add some distressing markings and flyspecks before you apply your seal coats.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Finishing: General Wood Finishing
KnowledgeBase: Finishing: High Speed Production
KnowledgeBase: Finishing: Refinishing
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com