CNC dust collection
Installing a flexible hose for dust collection with CNC machinery. March 14, 2001
My dust collection system consists entirely of rigid pipe. Now I'm planning on getting CNC equipment. What should I be aware of regarding the flex hose for CNC equipment?
The flex hose recommended consists of a 30-mil urethane that is wire-reinforced. This urethane material has a high tear strength, and abrasion resistance to handle the chip collection required for such woodworking machines. The flex hose handles particleboard applications very effectively. It is also flexible enough to handle the stress of traversing back and forth on the moving equipment. For even more stressful, abrasive conditions, you can request a 45-mil urethane flex hose. It is not quite as flexible as the 30-mil material, but is considerably more durable. Applications for sawdust trailer loading, and leaf collection/street sweeping are its common practice.
Curt Corum, forum technical advisor
Our dust collection system is 8" rigid metal pipe and we use a CNC router that has a moving gantry. To prevent the dust collection hose from causing problems, we installed a stanley barn door track system to the ceiling and use a separate trolley with a couple of screen door springs attached to the 4" dust collection hose to keep it up out of the way. This same track is also used for our vacuum lift to load heavy material onto the table. We bought our track and trollies from Grainger and it was a very cheap solution to our problem.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Computerization: CNC Machinery and Techniques
KnowledgeBase: Dust Collection, Safety, Plant Management
KnowledgeBase: Dust Collection, Safety, Plant Management: General
KnowledgeBase: Knowledge Base
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com