Converting board feet to metric
It's not as simple as it sounds. November 7, 2001
I have always used the term board foot. But some countries use the metric system. Is there a way to convert board feet to metric?
424bf = 1 cubic meter
One board foot or one square foot = 0.0929 square meter.
one foot = 0.3048 meter.
one cubic meter = 35.31 cubic feet and as you have 12 bd/ft in a cubic/ft you have 423.77 bd/ft in one cubic meter.
It would be nice if a board foot was really 1/12 of a cubic foot. But, a softwood 2x4x12' is really 1.5"x3.5"x12.0'. So, when converting to metric, do you use the nominal size of 2"x4"x12' or the actual size? Metric uses actual sizes, but BF uses nominal. For hardwoods, a piece that is 1-7/32" thick and 7.5" wide and 12' long is 7BF as is a piece that is 1.0" thick x 6.5" x 12'. The "soft" conversion in the post above will give you greatly different cubic metric volumes.
So, if you use the 424 number, appreciate that it is not accurate for converting actual volumes.
Gene Wengert, forum technical advisor
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Primary Processing: Yield Formulas
KnowledgeBase: Knowledge Base
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com