Dust collection pipe assembly tips
Helpful techniques for putting together a dust collection piping system. March 16, 2001
Are there techniques that will help when I assemble my dust collection piping?
Buy a pipe crimper. If you have a pop rivet gun, good. If not, self tapping screws work, but aren't as good. They tend to be sharp and can grasp onto particles in the air stream. Never rivet or screw in the bottom 1/3 of the pipe--this is where all the dust settles when the system is shut down, and the screw could snag material on startup, which will cause a clog. Forget the couplings they sell. Instead, crimp the pipe that is being sucked from into the pipe going to the collector.
I've almost always used the couplings--it's hard to crimp spiral pipe and takes too much time.
I use silicon caulking on my plastic pipe and don't see why you can't use it on metal if you support it with hangers from the ceiling. It seals and can be taken apart, but it's not easy.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Dust Collection, Safety, Plant Management
KnowledgeBase: Dust Collection, Safety, Plant Management: General
KnowledgeBase: Knowledge Base
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com