Oversize Cupboard Doors
Suggestions for trouble-free construction of wide, tall raised-panel cabinet doors. February 17, 2006
I have a client that wants some quite large pantry-like clothing closets, which will require several RP doors about 6' tall with widths close to 30". The job is red oak with stain and CV finish. I am curious how others have addressed the warping issue in a case like this.
From contributor T:
I haven't built any that wide, but I've built flat-panel doors 24" x 72" or so. The thing to do for big doors is to rough cut the frame parts and leave them to mellow for a couple of days before face-jointing. Also, don't do it with one panel. Put a centre rail or two in it. That said, I think 30" is too wide - but what do I know?
From contributor H:
Make them 1 3/8" thick just like any other interior door, just shorter. Heck, buy them already made 6/8 and re-work them down to 6/0.
From contributor D:
I do a furniture piece with a 5 foot 30" opening. Going with two doors, 4/4 with 2 inch stile and rails and rail in the middle. Doing this you are getting some pretty skinny RP's and they look kind of silly without the middle rail. I haven't had any problems at all.
From contributor C:
If you're worried about the stiles warping, laminate them out of two 3/4" thick pieces, let them sit for a few days, them plane them down to 1 3/8", which is a standard thickness for tooling and hardware. This should be a slam-dunk - don't worry.
From contributor P:
I run into this all the time. I tell everyone that I will be using catches on the doors (even though they are hung on euro hinges) and I use whatever size Rare Earth magnets necessary to keep things in line.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Cabinetmaking: Cabinet Door Construction
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review Woodweb.com's Copyright Policy.
The editors, writers, and staff at Woodweb.com try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at Woodweb.com after considerate evaluation,
and at their own risk.
865 Troxel Road
Lansdale, PA 19446
Copyright © 1996-2021 - Woodweb.com