I did the mahogany-veneered table below initially with TiteBond and an iron. Eventually it began to bubble. I would like some advice on vacuum veneering this 42x42x19 project. Would it be best to bag the whole table and attach both faces at the same time? Or is it better to make a larger 'veneer' with substrate/face veneer then attach it to the lattice work? Minimum radius is 4 inches.
From contributor R:
You would probably have to build a support frame to press the whole thing in one shot. Frame should seat an inch or so higher than the surface of the table so vacuum bag could go around the corners on the bottom. Not an easy proposition but it抯 doable. You may as well use Unibond 800 if you going to press with vacuum.